JGY- reinforced polymer mortar Features: 1, fire-resistant, high temperature resistance, corrosion resistance, good aging properties. 2, high strength, good operability plaster. 3, with good adhesion properties of the original concrete structure. 4, no shrinkage, basic does not produce cracks. 5, carbon dioxide, chloride, etc. through the poor, can prevent the carbonation of concrete and steel to prevent corrosion of the concrete. 6, mechanical properties similar to concrete, freeze-thaw resistance and durability very good. 7, resistance to other chemicals impedance is very good, and this material is non-toxic, harmless to human body. Scope: 1, concrete structures reinforced plaster. 2, with permeability, can be used for stainless steel wire mesh reinforcement. 3, for the repair of concrete structures honeycomb surface defects such vulnerabilities exposed tendons treatment. Physical performance indicators: Test items Performance test results flexural strength (Mpa) 28d 6.0 6.1 Compressive Strength (Mpa) 7d --- ≥21.5 28d> 20 ≥35 neutral resistance (mm) 28d <5.0 2.0 bond Strength (Mpa) at room temperature normal 28d> 1.0 1.8 thermal cycling 28d> 1.0 1.5 water permeation rate (g) <20 18 24h water absorption (g / m3) <1000 625 absorption coefficient (kg / cm2? h0.5) <0.5 0.4 Usage: 1, according to the water-cement ratio of 1: 4-5 mixing with water. 2. Take a clean bucket, add water, quantitative, while down while stirring with a low speed (1000 revolutions per minute or less) electric stirring rod for about 3-5 minutes, stirring once again stand 2-3 minutes after use . 3, according to the specific requirements for the construction or repair plaster can be. 4, each ingredient should be used within two hours. 5, the ambient temperature is above 35 ℃, shading devices should be set to avoid material loss exposure in direct sunlight. Grouting material manufacturers Tel 13031188870